Group 2

Group Members: Chris Cordell, Andrew Hardin, Andrew Masse

Plinko game on The Price is Right

Background

Inspired by the game Plinko featured on the popular American television gameshow The Price is Right, the original concept was to investigate potentially chaotic structure within the Plinko system. As will be discussed briefly below, this proved to be more difficult than was initially expected, and the collision based peg system was replaced with a series of magnets to create a magnetic Plinko board.

Problems with Original Plinko

Traditional studies of Plinko and other pinball billiard games have analyzed the aggregate statistics of the outcomes based on the starting position [1,2]. These analyses assume that each puck-pin interaction can only result in one of two possible outcomes: left or right. These analyses also assume that the puck must always continue downward without the possibility for upward motion, and they do not analyze the trajectory or starting conditions in detail.

In order to study this system, a simulation of the system has been created in two ways: using a Runge-Kutta integration method with an event detection loop to detect collisions between the puck and the pegs to solve the puck's motion due to gravity; and a simulation that calculated parabolic trajectories between pegs and root solved for the collisions. For both methods, upon the detection of a collision, the model calculates the reflection angle of the puck about the peg normal at the collision point with a user-defined coefficient of restitution. From this angle, a new initial velocity is determined and the process is iterated from that point. This procedure continues until the puck crossed the lowest row of pegs on the Plinko board.

Exponential divergence of collisions

Both methods have significant problems appropriately detecting collisions. The Runge-Kutta integrator often sets the time step so high as to miss collisions due to the simple nature of the equations of motion. Fixing the time step to some small value causes collisions to be detected correctly, but this results in a longer run time as well as the build up of numerical errors in the trajectory. Running two different maximum time steps for the same initial condition results in significantly different trajectories. The parabolic simulation is mostly immune to overstepping collisions at high (>0.8) coefficients of restitution, but for values of the variable low enough to provide the dissipation necessary for the onset of chaos, even the parabolic simulation has singularity issues that led to trajectories clipping the pegs.

In addition to simulation issues, a map of the initial position and velocity against the final cross-slope position reveals that there is no structure in the input space, and there are no basins of attraction within the system to the resolution to which we ran the simulation. Furthermore, no analysis of the data is able to produce a strange attractor. It is determined that this problem did not produce chaotic behavior that is qualitatively similar to the previously-studied and presumable similar pinball and billiard systems [3,4,5]. The results are, instead, distinctly random in nature and small perturbations yield extremely divergent behavior beyond even the weak chaos of ergodic motion. This is due to the exponential divergence of two similar trajectories as they evolve in the system and because there is no attractor limiting (dissipating) that divergent behavior.

Ski-Slope Dynamics

Mogul field on a ski-slope

Progression of attractor structure descending down the ski-slope

While Plinko as shown on the Price is Right is a random process, there are similar types of scenarios wherein an object descends through a regular field of obstructions that alter its trajectory as it descends. One such scenario is ski-slope dynamics [6]. In this scenario, a series of moguls are located on a slope, and a sliding object is allowed to descend under the force of gravity. As the sliding object interacts with the moguls, the trajectory is altered.

Lorenz created a simulation of this problem that shows significant chaotic behavior. Tracking cross slope velocity as a function of cross slope location for a variety of downslope positions shows the formation of an attractor, as shown in the image to the right. The progression of the attractor formation proceeds from top to bottom, then left to right as the object descends through the mogul field. Lorenz fixes downslope speed in his system, which is not totally identical to the Plinko system where the puck accelerates vertically. A fixed downslope speed can be thought of as the object reaching terminal velocity and only having the moguls redirect the trajectory, indicating that sufficient downslope is required to reach a terminal condition. The peaks of the moguls are similar in nature to the pegs of the Plinko board, in that any object approaching the peak will tend to get repelled. However, instead of a discrete collision as exists within Plinko, a ski-slope provides continuous force acting on the object. This serves to create a continuously varying trajectory which does not necessarily diverge from neighboring trajectories as was seen in Plinko. Lorenz provides a simulation which sets a framework for looking at ski-slope dynamics, but does not have experimental data to support the model.

The advantage of a ski-slope problem from a simulation aspect is that the governing equations of motion are now continuously varying without the discrete collisions inherent in the Plinko system. Thus ordinary differential equation solvers will not run into the same problems encountered during the simulations of the Plinko system, where setting a maximum time step ensures collision detection at the cost of numerical errors propagating throughout the trajectory. A smoothly varying equation of motion provides a well behaved model to simulate, as well as carrying the underlying chaotic structure which Lorenz shows in the form of an attractor in position and velocity space.

Combining Lorenz's observations with the original idea of investigating a Plinko board, an experiment and simulation have been developed to determine the chaotic behavior of a magnetic Plinko board. Instead of discrete collisions from a peg board, magnets will be used to continuously alter the puck trajectory as it descends through the field. Rather than using raised pegs which could still provide collisions, the magnets are embedded within the Plinko board so as to provide a smooth, unobstructed surface for the puck to slide along. This is not a perfect analog to the Lorenz simulation, as in that simulation each mogul affects the trajectory without regard to the presence of other moguls. For a magnetic Plinko board, there will be some magnetic force associated with all of the magnets in the board, not just the nearest magnet to the current point in the trajectory. Tracking of the trajectories will provide data in support of the magnetic Plinko simulation, to verify if the structures seen are physical in nature.

Methodology

To investigate the chaotic behavior of a magnetic Plinko board, both an experiment and a simulation have been set up. The experiment consists of constructing a low cost magnetic sheet which a magnetic puck can slide down. Trajectory information is collected with a camera connected to a computer with LabView software to track the motion of the puck each time it is dropped through the magnetic Plinko board. The simulation consists of MATLAB code written to model as closely as possible the physical parameters of the experimental setup. After verifying that the simulated trajectories compare qualitatively with the experimental results, an in depth investigation into the underlying attractor structure can be performed.

Experiment

Experimental Setup

There are three components to the experimental setup to obtain trajectory data for the magnetic Plinko scenario. First, the puck must be constructed so that it can slide down the Plinko board. The puck is made from Teflon to reduce the friction on the puck as it slides. The Teflon houses a magnet to create the magnetic force on the puck as it slides. A ball is attached to the top of the puck for ease of tracking with the camera system.

Next, the puck needs a magnetic Plinko board to slide down. Rare earth magnets have been inserted into a Plexiglas sheet that was predrilled to have a series of holes in a triangular formation with approximately 3 cm spacing. In this configuration, the magnets attract the puck, meaning that the magnet sheet represents the basins between moguls of the ski-slope dynamics problem. This sheet was found to create too strong of a magnet field by itself, as the puck would tend to attract to the magnets or flip over and fall off the board as it passed. To reduce the strength of the magnetic forces while still providing a sufficient force to noticeably alter the trajectories, a thin sheet of plastic was added to the top of the Plexiglas. This served to increase the distance between the Plinko board magnets and the puck magnet, which reduced the overall force. A total of 28 magnets distributed over 5 rows create the final magnet sheet. The plastic is black so that the ball on top of the puck is easily distinguishable.

Lastly, a camera system is required to capture the trajectories of the puck as it descends through the magnet sheet. An Allied Vision Technologies PIKE camera was connected to a computer and LabView was used for real time tracking and data collection of each run. LabView tracks the white ball on top of the puck at 200 frames per second, which shows up clearly against the totally black backdrop of the Plinko board. Trajectories are recorded in dimensions of pixels from the camera system.

Experiments would be conducted by starting the puck in one of four regions near the cross-slope center line. Two regions would be on the center line at slightly varying heights. The other two regions would be slightly offset from the center line (to the right) and at equal heights to the previous two regions. The puck would be placed into each of the four regions and released without imparting initial velocity or spin. Preliminary testing in simulation showed some interesting dynamics in the repulsive case; however, the initial trials showed that the puck was prone to flipping in the repulsive configuration. The experiment and simulation were reconfigured to test the attracting condition which proved to be more stable. This should still be a consistent model with the ski-slope dynamics, as the basins between moguls are effectively attracting the trajectories. 100 runs were performed from each initial drop region, for a total of 400 runs. The time and position history data for each run was saved for later analysis.

Simulation

To simulate the magnetic Plinko board, a MATLAB code has been written to integrate the equations of motion for the puck, taking into account accelerations due to gravity, friction, and the magnets as shown below. The gravitational acceleration depends on the tilt angle of the board. The acceleration due to friction depends on the tilt angle of the board and the kinetic friction coefficient. The direction of this force is opposite that of the velocity vector, but not dependent on the puck velocity. The acceleration from the magnets is modeled as a 1/r^2 function, which should be valid for small magnets spaced far apart. This force is determined for each magnet and summed together to get the net magnetic force. A negative value of the coefficient represents an attracting magnet while a positive coefficient represents a repelling magnet. Each of these forces is written in the frame of the magnetic sheet, where X is cross slope position and Y is downslope position. The origin is set to be the lower left magnet on the magnet sheet.

<math>\vec{a}_{g} = [0,-g\cdot\sin\theta]</math>

<math>\vec{a}_{f} = -\mu\cdot g\cdot \cos\theta \left [ \frac{V_x}{V},\frac{V_y}{V} \right ]</math>

<math>\vec{a}_{m} = \sum_{i=1}^{N_{magnets}}\left (\frac{k}{{R_{i}}^2}\right)\cdot \hat{R_i}</math>

Mapping of final cross-slope position to initial-cross slope position and magnetic force coefficient

To have the simulation match as closely as possible with the experiment, the parameters in the equations above need to be determined. The angle of the board is measured from the experimental setup. The coefficient of kinetic friction is estimated as the tangent of the angle where puck motion could be sustained. The magnet depth is measured from the construction of the board. To determine the correct coefficient for the magnetic force equation, a trade study is performed, varying initial cross-slope position and magnetic force coefficient until the trajectories qualitatively resemble those seen in the experiment. As is shown in the image to the right, the magnetic force eventually saturates the system, and the trajectories converge to the same paths. Thus the value shown in the table was chosen, as it represents trajectories which agree well with the experiment.

Simulation parameters

Parameter	Value
Tilt Angle	18<math>^{\circ}</math>
Gravity	9.81 <math>\frac{m}{s^2}</math>
Kinetic Friction	0.15
Magnet Depth	0.5 cm
Magnetic Force Coefficient	-0.005

Results and Analysis

The experimental data has been reduced to show the full trajectory of each run as well as plots of the cross-slope velocity as a function of cross-slope position as the magnet passes each row of magnets. Video has been created of some runs to demonstrate the experimental method. The simulation has been run to generate basins of attraction for initial conditions covering half of the horizontal spread of the Plinko board. Additionally, a sequence of data points have been run at a constant drop height and varying initial cross-slope location to generate attractor structure similar to that seen in the Lorenz simulations.

Trajectory Analysis

All experimental trajectories

The two videos shown below are taken from the experimental data. The first video shows a sequence of 5 runs to demonstrate the experimental process. A wand is used to hold the puck stationary, then liftedto release the puck into the magnetic sheet. This video also shows the sensitive dependence on initial conditions, as each puck drop is fairly close to the others, yet the trajectories vary. There is also a repeatability to the runs, as the first and last run are almost identical.

The second video and the image to the right show the trajectories for each run plotted with each other. The trajectories tend to follow the paths of least resistance, which means either a vertical drop or a diagonal row of magnets. If the puck passes near to a magnet, then its trajectory will be deflected such that it follows a diagonal. Since the initial conditions are clustered in the center of the board, these trajectories have a limited number of paths which they will attempt to follow down the board.

<videoflash>Tmf18EciFQs</videoflash>

<videoflash>3o23-CVlYyA</videoflash>

References

[1] http://phet.colorado.edu/en/simulation/plinko-probability. Plinko Probability. University of Colorado Active Simulations.

[2] Biesterfeld, A. “The Price (or Probability) Is Right.” University of Colorado at Boulder. Journal of Statistics Education. Volume 9, Number 3 (2001).

[3] Pring, S. R. Budd, C. J. “The Dynamics of a Simplified Pinball Machine.” University of Bath. IMA Journal of Applied Mathematics. 2011.

[4] Markarian, R. Pujals, E. J. Sambarino, M. “Pinball Billiards with Dominated Splitting.” Ergod. Th. & Dynam. Sys. Cambridge University Press. 2010.

[5] Arroyo, A. Markarian, R. Sanders, D. P. “Bifurcations of Periodic and Chaotic Attractors in Pinball Billiards with Focusing Boundaries.” Nonlinearity. IOP Publishing. 2009.

[6] Lorenz, E. "The Essence of Chaos." The Jessie and John Danz Lectures. UCL Press, 1995.